Not Sticking to the Bed

Not Sticking to the Bed

It is very important that the first layer of your print is strongly connected to the printer’s build platform so that the remainder of your part can be built on this foundation. If the first layer is not sticking to the build platform, it will create problems later on. There are many different ways to cope with these first layer adhesion problems, so we will examine several typical causes below and explain how to address each one.

Common Solutions

Build platform is not level

Many printers include an adjustable bed with several screws or knobs that control the position of the bed. If your printer has an adjustable bed and you’re having trouble getting your first layer to stick to the bed, the first thing you will want to verify is that your printer’s bed is flat and level. If the bed is not level, one side of your bed may be too close to the nozzle, while the other side is too far away. Achieving a perfect first layer requires a level print bed. Simplify3D already includes a useful bed leveling wizard that you guide you through the bed leveling process. You can find this wizard by going to Tools > Bed Leveling Wizard, and following the on-screen instructions.

Hinterlasse ein Kommentar

Alle Kommentare werden vor der Veröffentlichung moderiert

Beliebte Beiträge

  1. Gaps in Top Layers
  2. Over-Extrusion
  3. Problem: Extrusion startet nicht
  4. Not Sticking to the Bed
  5. Under-Extrusion

Ausgewählte Produkte

JETZT 27% SPAREN!
INKRAYON® | Glass (PEN-PET) Clear Blue - 3D Druck FilamentINKRAYON® | Glass (PEN-PET) Clear Blue - 3D Druck Filament
INKRAYON® INKRAYON® | Glass (PEN-PET) Clear Blue
26,90 € 36,90 €
2,69 € / 100g
JETZT 29% SPAREN!
INKRAYON® | Performance PLA - Blue - 3D Druck FilamentINKRAYON® | Performance PLA - Blue - 3D Druck Filament
INKRAYON® INKRAYON® | Performance PLA - Blue
24,90 € 34,90 €
2,49 € / 100g